Hello,
I have been looking at compiling uClibc ...
I just got it to compile ...
But now I have some questions regard gcc ... up until now I have been able
to get along fine with a boot strapped version of gcc ...
I now have these questions:
1.) After I build uClibc ... should I recompile gcc with uClibc ?
2.) When I built my boot strap gcc is the "--enable-shared" a good idea to
have? Can some explain if have this feature is good for embedded systems ...
I have some old emails saying "no" ...
Regards,
Jim
I got uClibc to build once I removed the PIC support from the config ... and
pointed the build to my correct kernel source ;-)
Is it importanted to build with " --enable-shared" ?
Jim
-----Original Message-----
From: James Don
Sent: Tuesday, January 07, 2003 6:54 PM
To: 'uclibc at uclibc.org'
Subject: RE: Help: Simple newbie build problem
Ok I think I know what this problem is ... I think it has to do with the way
I built my compiler ... I believe it has to do with the fact I did not build
gcc with the " --enable-shared" option ...
Any one know for sure?
I will keep reading ...
Jim
-----Original Message-----
From: James Don
Sent: Tuesday, January 07, 2003 6:31 PM
To: 'uclibc at uclibc.org'
Subject: Help: Simple newbie build problem
Hello,
Just hoping to find some help with a simple build problem I an having with
uClib.
First off here's some facts:
1.) I have built cross compilers 2.95.3 ... powerpc-linux-gcc with newlib
... etc
2.) I have build bootloader and kernel for embedded board ...
3.) Now I am building uClibc ... I changed the rules.mak file to have the
right CROSS=powerpc-linux- ...
Now here's my problem:
1.) I do this make defconfig
2.) Then I do this make
3.) Then I see this:
powerpc-linux-ld: cannot open
/home/jgdon/ppcgcc/lib/gcc-lib/powerpc-
linux/2.95.3/pic/crtbeginS.o: No such file or directory
make[1]: *** [shared] Error 1
make[1]: Leaving directory `/home/jgdon/ppcUClibc/uClibc
0.9.16/libpthread'
I have found the file crtbeginS.o in home/jgdon/ppcgcc/lib/gcc-lib/powerpc-
linux/2.95.3/ ... or one directory back of where my build is looking ...
Any advice would be much appreciated,
Jim
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
