Hi, We have the similar setup (CLLF 860T) and a Dell Optiplex GX110 as our RedHat 6.2 host. We had trouble in downloading due to problem with Ethernet speed. Once we connected a new Ethernet card with 10/100 Mbps support, the downloading and booting went smooth. The RPX-Lite has trouble with 100 Mbps interface as indicated by HHL documentation.
Hope this helps Govindan. "Code it clear rather than clever" --------------------------------------------------------------------- Govindan K Thrithala Tel: +91-80-226-7495x4033 Tejas Networks India Pvt. Ltd. Fax: +91-80-226 7494 49, Khanija Bhavan, Race Course Road Bangalore 560 001 ------------------------------------------------------------------- "I care for future, because I spend rest of my life there" -----Original Message----- From: [EMAIL PROTECTED] [mailto:owner-linuxppc-embedded at lists.linuxppc.org]On Behalf Of Zheng, Haifei Sent: Friday, December 15, 2000 12:01 AM To: 'linuxppc-embedded at lists.linuxppc.org' Subject: Continously reseting problem Hi, We have a CLLF860T from embedded planet. We are trying to install hardhat linux on the board. We have managed to transfer the kernel image using tftp. When the boot process starts the boot prompt (Linux/PPC load: root=/dev/nfs rw) and just sits there, after a few seconds the board reboots. If however we hit enter on the host machine when the boot prompt comes up, it proceeds to uncompress kernel, and boot it. But it then reboots again before getting much further. We think it may be a watch dog problem. Has anybody else had a similar problem? Haifei Zheng ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
