Tom Stefanski wrote: > I have a adatron bdi 2000 connected to my target board and have > successfully load the linux kernel and set breakpoint in schedule > However when I load my device driver, it's text section is a 0xD11D6060 > and the kernel is a 0xC00xxxxx. When is disassemble any routine in my > driver, I get all zeros. > > I have MMU xlate set in the config file and I program the mmu correctly > since I can break a schedule. Any help would be apprecciated > > > Tom > > >
Did you remember to specify the text address when you added the symbol file in gdb? If you didn't type 'help add-symbol-file' in gdb and it will explain where you can specify the starting text address of your device driver module. Neil -- /****************************************************************** *Neil Horman *Software Engineer *LVL7 Systems *13000 Weston Pkwy. *Cary, NC 27513 *(919)-865-2915 *nhorman at lvl7.com *PGP keyID 0xB5E1020A *http://www.keyserver.net/en *******************************************************************/ ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/