Grant Likely wrote: > On 7/11/07, Kevin Holland <[EMAIL PROTECTED]> wrote: > >> Grant, >> How do I set the MAC address? >> > > Badly, with an ugly hack. :-) > > >> When my ML410 board boots its Hardware >> address is set to 0. I looked through the message boards and can't seem >> to find what Im looking for. Thanks for your help. >> > > I set the mac addr with some Virtex specific code in > arch/ppc/boot/simple/embed_config.c. > > BTW, Please at least CC: the mailing list when asking questions. >
Pico cards pass the MAC address to linux via the board info struct - doesn't uboot etc. have a similar facility ? Pico registered a block of MAC addresses, uses them as card serial numbers and passes them via board info. -- Dave Lynch DLA Systems Software Development: Embedded Linux 717.627.3770 [EMAIL PROTECTED] http://www.dlasys.net fax: 1.253.369.9244 Cell: 1.717.587.7774 Over 25 years' experience in platforms, languages, and technologies too numerous to list. "Any intelligent fool can make things bigger and more complex... It takes a touch of genius - and a lot of courage to move in the opposite direction." Albert Einstein _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
