On Thu, 2007-08-23 at 06:36 -0700, Mirek23 wrote: > Could someone advice me how to configure Linux kernel to make use of the > Flash (with above mentioned partitions and JFFS2.
The Denx U-boot and Linux Guide (DULG) will tell you how to configure the kernel for MTD devices and will give some good general information: http://www.denx.de/wiki/view/DULG/FlashFilesystemsMTD > I do not know however which specific options to enable for MTD/JFFS2 since > it has many sub options. The following post has some relevant information for your setup: http://osdir.com/ml/linux.uclinux.devel/2005-12/msg00130.html > I do not know also where to place: > -the partition information (which I have mentioned above) The partition information probably should go in a file that you create for your board located at "drivers/mtd/maps/<your_file>.c" > -the start (0xFF800000) and end (0xFFBFFFFF) physical location of my Flash > memory. I think this information just needs to be defined in your board's .h file in u-boot. I don't think you need to specify this in any linux config files. I hope this info helps. Regards, Michael Willis Applied Research Labs - University of Texas [EMAIL PROTECTED] _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
