The MPMC would almost certainly be a better option here... Steve
> -----Original Message----- > From: > [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] labs.org] On Behalf Of Robert Woodworth > Sent: Thursday, August 30, 2007 7:45 AM > To: Grant Likely > Cc: [email protected] > Subject: Re: Xilinx Virtex boot > > On Wed, 2007-08-29 at 18:29 -0600, Grant Likely wrote: > > On 8/29/07, Robert Woodworth <[EMAIL PROTECTED]> wrote: > > > I'm trying to port Linux to a new Virtex Platform. The > kernel will not > > > uncompress, I get the following on the console: > > > > > > loaded at: 00400000 004FB19C > > > board data at: 004F9120 004F919C > > > relocated to: 00404054 004040D0 > > > zimage at: 00404E50 004F8409 > > > avail ram: 004FC000 04000000 > > > > > > Linux/PPC load: console=ttyUL root=/dev/xsa2 > > > Uncompressing Linux... > > > zlib_inflateInit2 returned 00506530 > > > exit > > > > > > Any ideas what causes this error?? > > > Is something mis-configured on my EDK project? > > > > > > > Possibly, do you know that EDK has your ram is configured correctly > > (ie. have you run a memory test application)? > > Yes, I ran the sample memory test application that EDK builds > automatically. It ran fine. > > The fact that the above prints on the console, tells me that the > zImage.elf is getting loaded at the correct start location > and that its > partly executing. > > What is the return code that I'm seeing?? I have been unable > to figure > that out from the source yet. > > > > > > > > I have 64MB DDR on the OPB *not* the PLB. > > > Is that a problem?? > > > > It shouldn't be the problem, but why are you doing that? > > We are building an image-processing application inside the FPGA. The > application is very memory intensive. I have been told that the PPC > always has priority on the PLB and that if I want to have my > FPGA module > have priority on memory, that I should place the memory and my FPGA > module on the OPB. Yes, this can significantly slow down the PPC, but > in my case the PPC is only used for UI and networking. > > I will actually build in *two* OPBs one for the memory + my module and > the second for the other peripherals. > > > Woody. > > _______________________________________________ > Linuxppc-embedded mailing list > [email protected] > https://ozlabs.org/mailman/listinfo/linuxppc-embedded > > _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
