All, I am attempting to get a new board booted up using NFS root file system. HW: Board based lightly on the MPC8360E_MDS
I have the kernel 2.6.23-dirty configured to use the Freescale QE driver. I am using U-boot 1.3.0 and am able to use the Ethernet there, so I know it is up. I am using the following bootargs from U-boot. bootargs=console=ttyS0,115200 root=/dev/nfs rw nfsroot=192.168.5.205:/usr/local/eldk/ppc_6xx ip=192.168.5.50:192.168.5.205:192.168.5.1::MIB305_50::off I can see during initial kernel load up that it loads: "ucc_geth: QE UCC Gigabit Ethernet Controller" However, later IP-Config claims there is no valid Ethernet device registered. Is there something I have to do specify what type of PHY device I am using? Perhaps a National DP8365 is not supported yet? Or perhaps the MDIO driver in linux is not looking at the correct MDIO address? In U-boot I am using PHY addr 0x01, could this present a problem? -Russ _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
