Hi all, I have a custom board with an MPC8358 (our board is based off of the MPC8360E-MDS development board) that has its eth's directly connected (GMII) to a Broadcom network switch part on the same board, with no PHYs between them. We've have been using a 2.6.16.18 kernel (from TimeSys) up until now, and I hacked in some crude support for no-phy configs forced to 100Mbit and 1Gbit speeds. Now I'm moving to 2.6.22 (with 8360 the patches from bitshrine.org), and I'm trying to understand how I should do this with device trees, the new PHY infrastructure, etc. Has anyone else needed this support? Does anyone have any suggestions as to how to tackle it?
Thanks, Steve -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Steve Hein ([EMAIL PROTECTED]) Engineering Diagnostics/Software Silicon Graphics, Inc. 1168 Industrial Blvd. Phone: (715) 726-8410 Chippewa Falls, WI 54729 Fax: (715) 726-6715 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
