On 2/6/08, khollan <[EMAIL PROTECTED]> wrote: > > Hi all, > > Thanks for the help so far! > I'm now running linux 2.6.21 on my custom virtex 4 board modeled after the > ml410. The cpu clock is 300MHz and the PLB bus is 175MHz. > > My question is which clock is the linux system clock that keeps track of the > date derived from? I set my date with rdate -s time.mit.edu at boot and > then compare with the date command and rdate -p time.mit.edu and they are > off by 20 or so seconds even just after a few minutes, this trend continues > and it will be off by a day after a few hours. I think I just don't have > something defined correctly but I can't figure out which.
The clock is maintained off of the PowerPC time base register (TBL, TBU). On Virtex ppc platforms, the time base frequency is supposed to be the same as the CPU clock. Can you figure out *exactly* how quickly the clock is drifting? How are you booting your Virtex platform? u-boot or a zImage.elf? If it's a zImage, the CPU clock frequency is set in arch/ppc/boot/simple/embed_config.c (search for CONFIG_XILINX and look for the line that sets bd->bi_intfreq). Make XPAR_CORE_CLOCK_FREQ_HZ in xparameters matches you CPU clock speed. Side note: you may notice that bd->bi_tbfreq is also used but not set; that's because bd->bi_intfreq and bd->tbfreq point to the same memory location. (It's kind of messed up that way, don't worry too much about it) If you're using u-boot, then u-boot will set the cpu frequency in the board info structure. Cheers, g. -- Grant Likely, B.Sc., P.Eng. Secret Lab Technologies Ltd. _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
