In reply to my message <[EMAIL PROTECTED]>
> I finally resolved my nightmare of getting linux-2.6.24/5... to work
> on my AMCC-440Epx - Sequoia spinoff board. Following a clue I derived
> from a reply from Wolfgang Denx, I went to the DENX Engineering site
> where I discoved and downloaded the ELDK for the ppc_4xxFP. the ELDK
> uses the ppc platform instead of the powerpc platform.  FINALLY the
Wolfgang replied At 06:22 PM 3/26/2008:
This is not exactly correct. Actually it supports both.

Ah thank you for that info. I only said what I said because the 4xxFP installation set things up to use the arch/ppc and to my delight, it worked! I look forward to and will do all I can to help get the arch/powerpc platform working on my Sequoia spin-off board.

I sent you email regarding my inability to do a ELDK build from scratch, did you get that? I'm trying to build it under a fully updated Fedora 7 system, and it hits the error:
  LD unable to locate -lssabi_krb5 .  Any clue?

thanks so much for your help,
Steve


_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded

Reply via email to