Hi , I am trying to port 2.6.25 kernel and RFS with NFS onto PQ2FADS-VR board and I run into following error when I boot the image with u-boot 1.3.2
Could anyone please let me know to how I need to debug the following error ? Any help is greatly appreciated in this regards. Thanks Jyotshna => bootm 400000 - 800000 ## Booting image at 00400000 ... Image Name: Linux-2.6.25 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1339847 Bytes = 1.3 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Booting using the fdt at 0x800000 Loading Device Tree to 007fc000, end 007fefff ... OK Xid mach(): done MMU:enter MMU:hw init MMU:mapin MMU:setio MMU:exit Using Freescale PQ2FADS machine description Linux version 2.6.25 ([EMAIL PROTECTED]) (gcc version 4.2.1 (Sourcery G++ Lite 4.2-82)) #52 Tue Nov 18 17:15:13 EST 2008 console [udbg0] enabled Entering add_active_range(0, 0, 8192) 0 entries of 256 used setup_arch: bootmem pq2fads_setup_arch() PCI host bridge /[EMAIL PROTECTED] (primary) ranges: MEM 0x0000000080000000..0x000000009fffffff -> 0x0000000080000000 Prefetch MEM 0x00000000a0000000..0x00000000bfffffff -> 0x00000000a0000000 IO 0x00000000f6000000..0x00000000f7ffffff -> 0x0000000000000000 pq2fads_setup_arch(), finish arch: exit Top of RAM: 0x2000000, Total RAM: 0x2000000 Memory hole size: 0MB Zone PFN ranges: DMA 0 -> 8192 Normal 8192 -> 8192 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0 -> 8192 On node 0 totalpages: 8192 DMA zone: 64 pages used for memmap DMA zone: 0 pages reserved DMA zone: 8128 pages, LIFO batch:0 Normal zone: 0 pages used for memmap Movable zone: 0 pages used for memmap Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: root=/dev/nfs ip=192.168.10.112:192.168.10.115::::eth0:off console=ttyCPM0,38400n8 nfsroot=/tftpboot/192.168.10.112.LTIB PID hash table entries: 128 (order: 7, 512 bytes) time_init: decrementer frequency = 16.500000 MHz time_init: processor frequency = 264.000000 MHz clocksource: timebase mult[f26c9b2] shift[22] registered clockevent: decrementer mult[439] shift[16] cpu[0] Console: colour dumm?Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 29572k/32768k available (2640k kernel code, 3196k reserved, 104k data, 91k bss, 104k init) SLUB: Genslabs=12, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1 Calibrating delay loop... 32.89 BogoMIPS (lpj=65792) Mount-cache hash table entries: 512 net_namespace: 440 bytes NET: Registered protocol family 16 PCI: Probing PCI hardware Can't get bus-range for /[EMAIL PROTECTED], assuming it starts at 0 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered JFFS2 version 2.2. .. 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) pci_hotplug: PCI Hot Plug PCI Core version: 0.5 ttyCPM0 at MMIO 0xf0011a00 (irq = 40) is a CPM UART ttyCPM1 at MMIO 0xf0011a20 (irq = 41) is a CPM UART loop: module loaded eth0: fs_enet: 00:e0:0a:0b:79:01 eth1: fs_enet: 00:e0:0c:00:79:01 CPM2 Bitbanged MII: probed physmap platform flash device: 00800000 at ff800000 CFI: Found no physmap-flash.0 device at location zero physmap-flash physmap-flash.0: map_probe failed of-flash fe000000.flash: do_map_probe() failed mice: PS/2 mouse device common for all mice TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 RPC: Registered udp transport module. RPC: Registered tcp transport module. IP-Config: Guessing netmask 255.255.255.0 IP-Config: Complete: device=eth0, addr=192.168.10.112, mask=255.255.255.0, gw=255.255.255.255, host=192.168.10.112, domain=, nis-domain=(none), bootserver=192.168.10.115, rootserver=192.168.10.115, rootpath= Looking up port of RPC 100003/2 on 192.168.10.115 Looking up port of RPC 100005/1 on 192.168.10.115 VFS: Mounted root (nfs filesystem) readonly. Freeing unused kernel memory: 104k init Warning: unable to open an initial console. Kernel panic - not syncing: No init found. Try passing init= option to kernel. Rebooting in 180 seconds..
_______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded