Hi all, I was wondering if anyone got the XUPV2P board successfully up and running with a recent 2.6 kernel?
I didn't succeed. I tried the newest kernel from xilinx git (2.6.27) and also an older one, 2.6.22 (also from xilinx git). For the newer I used the "device-tree" as bsp. For the 2.6.22 I just copied over the xparameters_ml300.h file. In both cases no output at all was observable at the uart. Not even a single sign from the uart at any time... Strange is, the same download.bit file is working with a 2.4 kernel. Could it be a kernel .config issue? But can this really be a software/kernel issue? For the 2.4 kernel there was an output from the "bootloader" (some addresses and the "Loading..." information) even for wrong configured kernels... On this list I was reading something about setting the uart clockfreq correctly in the .dts (it was not set at all, I have to stick with EDK 9.1). But this didn't help for me. To boot the FPGA I have to use an ace file on a cf-disc. For this I use the download.bit file together with the simpleImage.virtex405-XUPV2P.elf (on 2.6.27) or zImage (on 2.6.22)... Any suggestions on this? Thanks a lot! Regards, Jan _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded