Hi Gents,
I have recently acquired a Microsemi IGM-1100i Grandmaster. Unlike my old
grandmaster, a TM2000A, this one isn't plug and play and being new to PTP
I'm kinda lost.
Per the user manual from the manufacturer my config is as follows:
PTP MASTER CONFIGURATION WITH PROFILE Default:
PTP State : enable
PTP Max Number Clients : 4
PTP TTL : 20
PTP DSCP : 25
PTP Dither : enable
PTP Two Steps : enable
PTP Announce Limit : 2
PTP Sync Limit : -6
PTP Delay Limit : -2
PTP Priority 1 : 200
PTP Priority 2 : 200
PTP Domain : 0
PTP Client-Timeout : 500
PTP Announce-Timeout : 4
PTP Vlan-Id : 20
PTP Timescale : AUTO
by going through the help file online the config file I've got so
farlooks like this:
[global]
logging_level 5
tx_timestamp_timeout 10
slaveOnly 1
dscp_general 25
dscp_event 25
priority1 200
priority2 200
assume_two_step 1
[eth0]
any suggestions on how I can get the ptp4l settings to talk to this
infernal device?
TIA,
Andrew
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Linuxptp-users mailing list
Linuxptp-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linuxptp-users
