From: Len Brown <[email protected]> Do for C3 what the previous patch did for C2.
The C2 patch was in response to a highly visible and multiply reported C-state/turbo failure, while this change has no bug report in-hand. This will enable C3 in Linux on systems where BIOS overstates C3 latency in _CST. It will also enable future systems which may actually have C3 > 1000usec. Linux has always ignored ACPI BIOS C3 with exit latency > 1000 usec, and the ACPI spec is clear that is correct FADT-supplied C3. However, the ACPI spec explicitly states that _CST-supplied C-states have no latency limits. So move the 1000usec C3 test out of the code shared by FADT and _CST code-paths, and into the FADT-specific path. Signed-off-by: Len Brown <[email protected]> drivers/acpi/processor_idle.c | 21 +++++++++++---------- 1 files changed, 11 insertions(+), 10 deletions(-) --- http://git.linuxtv.org/v4l-dvb.git?a=commitdiff;h=a6d72c189f6c4292ba1a323e8af24083790529f8 diff --git a/drivers/acpi/processor_idle.c b/drivers/acpi/processor_idle.c index 8f6da9a..2c543b4 100644 --- a/drivers/acpi/processor_idle.c +++ b/drivers/acpi/processor_idle.c @@ -316,6 +316,17 @@ static int acpi_processor_get_power_info_fadt(struct acpi_processor *pr) pr->power.states[ACPI_STATE_C2].address = 0; } + /* + * FADT supplied C3 latency must be less than or equal to + * 1000 microseconds. + */ + if (acpi_gbl_FADT.C3latency > ACPI_PROCESSOR_MAX_C3_LATENCY) { + ACPI_DEBUG_PRINT((ACPI_DB_INFO, + "C3 latency too large [%d]\n", acpi_gbl_FADT.C3latency)); + /* invalidate C3 */ + pr->power.states[ACPI_STATE_C3].address = 0; + } + ACPI_DEBUG_PRINT((ACPI_DB_INFO, "lvl2[0x%08x] lvl3[0x%08x]\n", pr->power.states[ACPI_STATE_C2].address, @@ -533,16 +544,6 @@ static void acpi_processor_power_verify_c3(struct acpi_processor *pr, return; /* - * C3 latency must be less than or equal to 1000 - * microseconds. - */ - else if (cx->latency > ACPI_PROCESSOR_MAX_C3_LATENCY) { - ACPI_DEBUG_PRINT((ACPI_DB_INFO, - "latency too large [%d]\n", cx->latency)); - return; - } - - /* * PIIX4 Erratum #18: We don't support C3 when Type-F (fast) * DMA transfers are used by any ISA device to avoid livelock. * Note that we could disable Type-F DMA (as recommended by _______________________________________________ linuxtv-commits mailing list [email protected] http://www.linuxtv.org/cgi-bin/mailman/listinfo/linuxtv-commits
