Odette:

I did check this and no, it is not checked.

Like I said, if I go to the shell on the router, I can ping hosts on the
wired and wireless networks just fine.  However, if I go on a wired or
wireless host, I cannot ping hosts on the other network.

Ryan

On Thu, Jan 26, 2012 at 6:21 AM, Odette Nsaka <[email protected]>wrote:

> **
> Hi Ryan,
>
>   just to be sure: take a look to the check box
>
>     "Block Private Networks"
>
> in the section
>
>    "Private networks"
>
> at the bottom of the page
>
>    "Interfaces    ==>    <WiFi interface>"
>
> and verify it's NOT checked
>
> Bye
>
>    Odette
>
>    --
> Odette Nsaka <[email protected]>
>
>   Il giorno mer, 25/01/2012 alle 22.57 -0600, Ryan Sommers ha scritto:
>
> First, my setup:
>
> WAN: vr0
> LAN bridge0
> Internal: vr1
> wifi: ath0
>
> bridge0: x.x.x.1
> bridge0 members: ath0, vr1
>
> DHCP is serving up addresses from the x.x.x network and I'm using NAT
> for Internet access.
>
> Everything is working correctly except that hosts on wifi can't
> connect to hosts on vr1.  But, Wifi hosts are able to connect to the
> internet through the x.x.x.1 gateway just fine.  And, hosts on the
> wired LAN can connect just fine.  So it's almost like the bridge is
> half working... It's passing packets between the member interfaces and
> the assigned IP, but not between member interfaces...
>
>
> Ideas?
>
> Thanks,
> Ryan
>
>
>
> _______________________________________________
> List mailing list
> [email protected]
> http://lists.pfsense.org/mailman/listinfo/list
>
>


-- 
Ryan P Sommers
[email protected]
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to