On 27 January 2012 12:16, Jostein Elvaker Haande <[email protected]> wrote: > When I go to the PPTP VPN configuration page [1], both the RADIUS > server, RADIUS port and RADIUS accounting port are all set to 1. If I > try to change either of them to their respective values, they are not > stored when I click save. Even if I try to disable RADIUS auth, and > change any of the other values (read: server address and remote > address range), these aren't stored either. I've tried a dozen > different combinations, and some even yield a PHP error [2].
Hello again, Just posting this here as a reply to my own question after I received some hands on help from Jim on IRC (##pfsense @ Freenode). To solve this issue, do the following: 1) Make note of your current configuration 2) SSH into your pfSense box 3) Enter the console 4) Run the command "viconfig" to edit the config file (this is a wrapper to correctly edit the config file by hand) 5) Navigate down the the <pptpd> section of the config 6) Remove everything from <pptpd> to </pptpd> 7) Save the config file 8) In the web gui, proceed to VPN -> PPTP 9) Reconfigure your PPTP service according to the details you've written up earlier 10) Save At this point, you should be able to test and verify that your PPTP service is again up and working. Thanks for your help Jim, really appreciate it! :) And yes, have good weekend! -- Yours sincerely Jostein Elvaker Haande "A free society is a place where it is safe to be unpopular" - Adlai Stevenson http://tolecnal.net -- tolecnal at tolecnal dot net _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
