On Wed, Apr 4, 2012 at 9:49 PM, Antonio Cortes Alhambra (INCATEL) <[email protected]> wrote: > Dear friends: > > > > last week I replaced my old pfSense 1.2.3 with a new > hardware with pfSense 2.0.1 > > I made a new configuration similar to the previous firewall. Same WAN IP > and LAN IP than older. > I have an FTP server on the LAN, which meets requirements active > and pasives. > In the pfSense 2.0.1 I proceeded to do what I did earlier in 1.2.3, > ie nat configure tunnel (port forward) to port 21, and > automatically create the associated rule to allow traffic. > > > To connect from the Internet in passive mode, with pfSense 1.2.3 works > perfectly, however with pfSense 2.0.1 there is not response to a ls or > dir command, and I can not transfer files. > What is the difference? What other settings must be configured manually in > version2.0.1? >
Can you be more detailed on your configuration? How you allowed range or nat or rdr ....! Normally on 2.0.x you do not need to do anything else apart forwarding port 20 to your server! There are corner cases that are handled through setting debug.pfproxy=1 > > > thanks > > > > Atte., > > Antonio Cortés Alhambra > > > > > > > _______________________________________________ > List mailing list > [email protected] > http://lists.pfsense.org/mailman/listinfo/list > -- Ermal _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
