Did you create outbound NAT rules for both WAN interfaces? Did you set the gateway to the failover group for the inbound pass rules on the LAN interface? Have you checked the gateway statuses in the menu "Status->Gateways" to make sure pfSense really thinks one of the gateways is down?
Rob ----- Original Message ----- From: "Denis Witt" <[email protected]> To: [email protected] Sent: Wednesday, April 10, 2013 5:10:41 AM Subject: [pfSense] Dual-WAN Failover Hi List, we have the following setup: 1. WAN1 => SDSL 6/6 MBit 2. WAN2 => VDSL 50/10 MBit 3. LAN We want to use WAN2 as Default-Gateway, for most of our traffic. WAN1 should only be used if WAN2 isn't available (failover). So we created a Gateway Group (failover): WAN1 = Tier 2 WAN2 = Tier 1 Also we created the following floating rule: Direction: out Interface: WAN1, WAN2 Proto : any Gateway : failover Everything works fine when both WANs are available. WAN2 is used as the preferred one. When one of the WANs goes down Internet is gone, so there is no failover... When we use Tier1 for both lines everything works fine (load balancing and failover) but we don't want to use load balancing. What are we missing? Thanks in advance. -- Best regards Denis Witt _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
