Hi Adam Am 10.12.13 01:54 schrieb Adam Thompson: > Spurious signal 11 (SEGV) messages tend to indicate faulty hardware, in > my experience. > Most typically, bad or marginal RAM. This device is quite new, embedded industrial design, 2GB of RAM.
Right now I run Linux on it to test: The same bandwith test (sending /dev/zero to the box) runs without problems and with significantly higher throughput than under pfsense. Under Linux no interruption occurs and the stream is steady at a rate of around 80MB/s (compared to pfsense where the link goes down after ~30-60s or so). Even if I add a second and a third stream to the second and third interface, the system stays stable, cpu then goes up to 100%, but each stream is steady at 55 to 65MB/s, now since over an hour. So I think the hardware is ok. The bad RAM theory I still have to follow. Regards, Adrian. _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
