yep, i think so. all the needed ports have the right tags, also vlan 2 also used on the same ports, just works.
switch operates in layer 2 mode. Am 28.02.2014 07:33, schrieb Ryan Coleman: > When I set mine up they were pretty straight-forward, I didn’t have to do > much inside of pfSense to get it going. > > So my thought is this: Is your switch configured correctly for VLAN3? > > On Feb 28, 2014, at 12:32 AM, J. Echter <[email protected]> > wrote: > >> Hi, >> >> i have 3 vlan's on my LAN interface. >> >> 2 of them working nicely. >> >> With the third i got trouble. >> >> I can access local network devices, but i cannot access internet. >> >> traceroute stops at 192.168.4.1 (vlan3 if address). >> >> default allow everything to any rule is added, dns forwarder listens on >> that ip (dns resolution works). >> >> Firewall logs don't show anything. >> >> pfSense 2.1 also was rebooted. >> >> What could be wrong with my setup? >> >> regards >> >> Juergen >> _______________________________________________ >> List mailing list >> [email protected] >> http://lists.pfsense.org/mailman/listinfo/list > _______________________________________________ > List mailing list > [email protected] > http://lists.pfsense.org/mailman/listinfo/list _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
