Curiously, the USB stack noticed the device went away, and came back with the off/on sequence.
Anyhow, I know that is insufficient for this device now. Thanks for responding! On Fri, Apr 18, 2014 at 2:41 AM, Seth Mos <[email protected]> wrote: > On 18-4-2014 0:49, Ryan Coleman wrote: >> I’ve found many devices do not honor this. > > +1 > > There is a AT command to reset the device, but this has the unfortunate > side effect that it can cause FreeBSD to kernel panic. I noticed this > when I was working on the 3G support. > > Regards, > > Seth > >> >> >> On Apr 17, 2014, at 2:40 PM, Vick Khera <[email protected]> wrote: >> >>> On Thu, Apr 17, 2014 at 1:23 PM, Oliver Hansen <[email protected]> >>> wrote: >>>> Hi Vick, I don't think I have much information for you but I have seen >>>> those >>>> similar logs before. I don't use mine as a backup but as a mobile router >>>> for >>>> events and only a couple of times a year. Usually in my experience it has >>>> been when there is not a strong signal that I see these problems. Because >>>> yours has worked just fine in the same place this may not be the cause. >>> >>> I managed to get someone to physically unplug and re-insert the >>> device. Once I re-saved the PPP config, it connected immediately. >>> Clearly the usbcontrol power_off/power_on was not sufficient. >>> >>> I hope this is not a regular occurrence :( >>> _______________________________________________ >>> List mailing list >>> [email protected] >>> https://lists.pfsense.org/mailman/listinfo/list >> >> _______________________________________________ >> List mailing list >> [email protected] >> https://lists.pfsense.org/mailman/listinfo/list >> > > _______________________________________________ > List mailing list > [email protected] > https://lists.pfsense.org/mailman/listinfo/list _______________________________________________ List mailing list [email protected] https://lists.pfsense.org/mailman/listinfo/list
