top -Sa says
11 root 2 155 ki31 0K 16K CPU1 1 46.8H 199.46% [idle]
In fact cpu usage goes to 100% when I reload home page and goes down
after a few seconds.
I think the problem is not important.
Best regards,
*Guillaume JULLIEN*
www.aquilog.fr
Mobile 06 24 68 25 24
Fax 05 57 96 83 58
Mail [email protected] <mailto:[email protected]>
Web www.aquilog.fr <http://www.aquilog.fr>
Le 10/03/2015 18:30, Manojav Sridhar a écrit :
If you have Device polling enabled it will use the "idle" cycles to
poll the Ethernet devices for traffic instead of interrupts as I
understand it. Disable it and you should see a top
also a
top -Sa
on your console will show all process including the process that is
hogging the CPU
On Tue, Mar 10, 2015 at 9:52 AM, Guillaume JULLIEN
<[email protected] <mailto:[email protected]>> wrote:
Hello,
Since I upgraded my pfsenses to version 2.2, they more than often
display 100% cpu load.
I'm testing an installation on an Alix APU1D.
no extra addon installed
only one service defined : DHCP
only my laptop connected on lan interface
If I plug WAN interface to my LAN CPU load can be 100% even with
no particular network traffic.
?
Any advice ?
--
*Guillaume JULLIEN*
www.aquilog.fr
Mobile 06 24 68 25 24
Fax 05 57 96 83 58
Mail [email protected] <mailto:[email protected]>
Web www.aquilog.fr <http://www.aquilog.fr>
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
