I see why you would think that but that's how the rules are set up.
It's to allow the traffic out to 192.168.4.39:22. In essence the port forward
always allows the inbound traffic and the firewall rule allows it to get out to
192.168.4.39:22.
Is it not working for you?
I suppose one could make an argument that a rule referencing a LAN
subnet IP should be on the LAN interface?
--
Steve Yates
ITS, Inc.
-----Original Message-----
From: List [mailto:[email protected]] On Behalf Of Ezsra McDonald
Sent: Wednesday, October 19, 2016 1:59 PM
To: [email protected]
Subject: [pfSense] NAT Associated filter wrong
I am new to pfsence. It is a very nice firewall.
I am running 2.3.2-p1
When I use the Associated filter rule option setting up a port forward It does
not seem to create the firewall filter correctly.
I created the following Port Forward:
Port Forward
-------------------------
Interface: WAN
Protocol: TCP
Source: *
Source Port: *
Dest Address: WAN Address
Dest Port: 22039
NAT IP: 192.168.4.39
NAT Port: 22
The following firewall filter was automatically created and linked:
Firewall Rule WAN
---------------------------
Protocol: IPv4 TCP
Source: *
Source Port: *
Destination: 192.168.4.39
Port: 22
I expected the Firewall filter to be:
Firewall Rule WAN
---------------------------
Protocol: IPv4 TCP
Source: *
Source Port: *
Destination: WAN Address
Port: 22039
What am I doing wrong?
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
