Settings are as follows: Enable Compliance evaluation: YesSchedule: Every 1 Days effective 2/1/1970Enable User Data Profiles: Yes I assume that the schedule is the reason why the evaluation is only happening once a Day? If that is the case, what is the use of the schedule that I configure when I do a deployment? Or is this one of the case where the Schedule of the deployments need to be greater then that of the Client settings? From: [email protected] Date: Thu, 23 Jul 2015 13:29:44 -0500 Subject: Re: [mssms] Help with Compliance\Baseline deployments To: [email protected]
What do you have 'Compliance Settings' set as in the 'Client Settings?'----------------------------------------------- Adam Juelich Pulaski Community School District Client Management Specialist 920-822-6075 On Thu, Jul 23, 2015 at 10:58 AM, Mark Evers <[email protected]> wrote: I need some help with deploying a baseline. The baseline is a simple one, it consists of a single compliance settings, that checks a registry setting and re-mediates it if needed. I have deployed it to a small collection of computers, however just over half has checked in and are now complaint, the rest are sitting int the Unknown state, it was deployed about 20 hours ago. I checked one of the computers in question and check the Configuration tab of the agent, and the baseline is listed, but as un-evaluated. I initially set the compliance to run on a reoccurring schedule of once an hour, I have since changed it to only run once. The question I have is why does it not run when it first sees it? Am I setting something incorrect?
