No. I am not sure why it is doing that. I can honestly say that no machine will take an image anymore. Only thing that has changed is installing SCCM 2012 SP2 and ADK for Windows 10. Can't believe that would cause this!
From: [email protected] [mailto:[email protected]] On Behalf Of Keith Garner (HotMail) Sent: Friday, September 11, 2015 3:31 PM To: [email protected] Subject: RE: [MDT-OSD] Failing TS Why did the machine go back in time? Do other machines that don't break the laws of physics continue without error? :) Was there a big change in TimeZone, were the machines just wildly out of sync? Executing command line: "C:\_SMSTaskSequence\OSD\ICC0001E\ccmsetup.exe" /useronly /source:C:\_SMSTaskSequence\OSD\ICC0001E /config:MobileClient.TCF /status:536 OSDSetupHook 9/11/2015 5:02:42 PM 1928 (0x0788) Process completed with exit code 0 OSDSetupHook 9/11/2015 2:08:31 PM 1928 (0x0788) From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Linkey, Mike Sent: Friday, September 11, 2015 12:40 PM To: [email protected]<mailto:[email protected]> Subject: RE: [MDT-OSD] Failing TS Here you go. I don't see anything bad.... From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Keith Garner (Hotmail) Sent: Friday, September 11, 2015 2:03 PM To: [email protected]<mailto:[email protected]> Subject: RE: [MDT-OSD] Failing TS Can you share the Smsts.log (compressed). From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Linkey, Mike Sent: Friday, September 11, 2015 10:27 AM To: [email protected]<mailto:[email protected]> Subject: [MDT-OSD] Failing TS We have upgraded our server to 2012 SP2 and CU5. We still have MDT 2012 Update 1 installed, 2013 Update 1 is in the works if I can keep other stuff from breaking. We have also upgraded the ADK for Windows 10 also. Now our existing Task Sequences are failing! I have been scratch my head on this and I just don't get it. It runs all the way up to this step: [cid:[email protected]] Once it gets there, it says it is installing the ConfigMgr client for a few minutes, then just blows out of the TS and straight to the login screen for Windows. It never finishes the TS, just dies. I have never seen this before! I am guessing something with the upgrade and I may need to recreate my Task Sequences to fix? If that is the case, I will get on 2013 Update 1 since I will need to create new ones then. Any input/insight/thoughts are much appreciated. Mike L.
