Most likely missing drivers for the VM disk controller.
--
There are 10 kinds of people in the world...
those who understand binary and those who don't.
From: [email protected] [mailto:[email protected]] On
Behalf Of Jeff Poling
Sent: Thursday, November 5, 2015 11:15 AM
To: [email protected]
Subject: [MDT-OSD] UDI Wizard "No supported NTFS Volumes Found"
I am PXE booting a VMware virtual machine in order to run a MDT-integrated
ConfigMgr 2012 R2 task sequence. . .PXE boot works fine and the task sequence
starts without issue. It does an initial partition and format of the disk and
then launches the UDI Wizard. On the Volume page of the wizard, though, no
volumes are available for selecting as the target drive and there is an error
stating "No Supported NTFS volumes found."
Diskpart from WinPE launches fine and shows volumes are there. SMSTS.log,
bdd.log, and osdsetupwizard.log do not show anything obvious as a cause for the
issue.
If the disk is accessible from WInPE via standard means (TS formats drive OK
and I can see volumes from Diskpart), but not from the UDI wizard, what should
I look at? Has anyone experienced this?
Thanks,
Jeff
