This did the trick, thanks! Strange that my method works for every other model. :/
From: [email protected] [mailto:[email protected]] On Behalf Of Toby Beaupre Sent: Tuesday, January 26, 2016 11:38 AM To: [email protected] Subject: [mssms] RE: Apply Drivers step not launching during imaging Here's my query [cid:[email protected]] Toby From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Murray, Mike Sent: Tuesday, January 26, 2016 1:28 PM To: [email protected]<mailto:[email protected]> Subject: [mssms] Apply Drivers step not launching during imaging See below, I've tried every combination of WMI query options I can think of. OptiPlex 9020, Win8.1 image, it won't run this step. I've run "WMIC ComputerSystem get Model" at the command prompt, and the value is populated. Any other ideas? [cid:[email protected]] Best Regards, Mike Murray Desktop Management Coordinator - IT Support Services California State University, Chico 530.898.4357 [email protected]<mailto:[email protected]> ________________________________ Confidentiality Note: This email message, including any attachment(s), is for the sole use of the intended recipient(s) and may contain information that is confidential, privileged, or otherwise protected by law. Any unauthorized use, disclosure, or distribution of this communication is strictly prohibited. If you have received this communication in error, please contact the sender immediately by reply email and destroy the original and all copies of the email, including any attachment(s).
