Hai,
I am using imx23 evk board and L2.6.31_10.05.02_ER_source(Ltib)
BSP to build images,
doing fine with images but not able to get eth0 after i booted
from sdcad, while configuring Ltib i selected
boot stream option and i set the ip-address
started networking, enabled Interface 0 and set the ip,
broadcast netmask and gateway address
--
*Regards
Jayanthkumar
9844598977
*
_______________________________________________
LTIB home page: http://ltib.org
Ltib mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/ltib
