Hi Jayanthkumar, This is not a BSP that is part of the public project, so it may be worth asking the vendor for help.
Looking at your log, no network device is detected. It could be a number of issues causing this. Make sure the kernel you are building has support for the network device on this board enabled. Also, if the driver has been built as a kernel module, make sure that this module gets installed (with modprobe) before trying to set up this device. Regards, Stuart On 25/01/13 09:45, jayanthkumar.m.j kumar wrote: > > Hai, > I am using imx23 evk board and > L2.6.31_10.05.02_ER_source(Ltib) BSP to build images, > > doing fine with images but not able to get eth0 after i > booted from sdcad, while configuring Ltib i selected > > boot stream option and i set the ip-address > > started networking, enabled Interface 0 and set the ip, > broadcast netmask and gateway address. > > But im not able to get eth0, while booting it showing > "IP-Config: No network devices available" > > with this mail i attached the boot information, Please do needed. > > > -- > /Regards > Jayanthkumar > 9844598977 > / > > > > > > _______________________________________________ > LTIB home page: http://ltib.org > > Ltib mailing list > [email protected] > https://lists.nongnu.org/mailman/listinfo/ltib > _______________________________________________ LTIB home page: http://ltib.org Ltib mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/ltib
