Felix- I've seen this warning message before on an LTSP server which was running the XFree86 3.3.6 Mach64 server. Whenever switching back and forth between the console and the X server via <(Ctrl-)Alt-F?> this warning would be spit out at the console. Ignore it. The X server was running fine when it was doing this. I think this is a red herring (a distraction from the true solution).
Sounds like you just need to tweak your X configuration. Make sure your monitor supports the default refresh/sync rates. When you say you've tried the troubleshooting steps, does that mean you've tried booting into runlevel 3 and running /tmp/start_ws from the workstation console? If so, what were the error messages reported by the X server? This is the direction you need to go to solve the problem. Jason > Date: Wed, 29 May 2002 15:55:56 +0100 > From: "Felix Laate" <[EMAIL PROTECTED]> > > I have problems with the XF86_Mach64 server (I think). As the client boots it gets past the > initial steps, the kernel comes over, the Mach64 module is activated, but then the screen > goes black! > > I tried to do all the stuff mentioned in the LTSP-troubleshooting guide, but to no awail- > > I tried Ctrl-ALt-F1 and this is what the thing says: > > mach64ProgramClkMach64CT: Warning: Q < 10.66666667 > > Could anybody help me (please) > > Felix Laate _______________________________________________________________ Don't miss the 2002 Sprint PCS Application Developer's Conference August 25-28 in Las Vegas -- http://devcon.sprintpcs.com/adp/index.cfm _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.openprojects.net
