Thank you sir, your suggestions were spot on. This method of assistance is wonderful, thanks again.
-----Original Message----- From: Ken Godee [mailto:ken@;perfect-image.com] Sent: Monday, October 28, 2002 4:52 PM To: Gerson Caicedo Subject: Re: [Ltsp-discuss] Network card problems with RH7.3.......... Is there an "Onboard" ethernet on this motherboard? If so, get into the bios and see if you can disable it. I thought the LNE100TX used the tulip driver. There might be some confusion between eth0 / eth1 Onboard I believe is auto assigned eth0. > I purchased a Linksys LNE100TX version4.1 network card with a > DisklessWorkstation.com bootrom installed on the card, installed this > card on a brand new motherboard with a AMD 1.2Ghz processor and 128mb of > memory. This �thin client� runs off a brand new COMPAQ DL380 with LTSP > 2.1.1 installed. The LTSP software was purchased from LTSP.org (no time > to get from mirror) and installed without problems, when I try to > connect to the server the client gets an IP address from the server, I > get the �dots� (the kernel loading, I think). All goes well till I get > the following message: > > VFS: mounted root (ext2 filesystem). > Freeing unused memory: 192k freed > > Running /linuxrc > Mounting /proc > Linuxrc: Installing sis900 driver > Modprobe sis900 > /sbin/insmod /lib/modules/2.4.18-ltsp-1/kernel/drivers/net/sis900.o > Using /lib/modules/2.4.18-ltsp-1/kernel/drivers/net/sis900.o > Symbol version prefix � > Sis900.c: v1.08.02 11/30/2001 > PCI: Found IRQ 3 for device 00:01.1 > PCI: Sharing IRQ 3 with 00:0b.0 > Eth0: Unknown PHY transceiver found at address 1. > Eth0: Using transceiver found at address 1 as default > Eth0: SiS 900 PCI Fast Ethernet at 0xd400, IRQ 3, 00:07:95:34:7e:7b. > Running dhclient > > ERROR! No dhcpd-eth0.info file > This usually indicates the dhclient did not get > a response from the DHCP server, or the NIC driver > working properly with the network card > > Kernel panic: Attempted to kill init! > > I am new to linux, I am in the process of getting my company off > MICROSOFT products as soon as I can get LTSP and LINUX working in my > environment. Any help with these issues would be greatly appreciated. > ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.openprojects.net
