> Have you tried orinoco_pci? I tried that and it wouldn't load beacuse of an IO/IRQ paramaters issue. To solve this would I have to edit my modules.pcimap file before I load it and if so, would I do that by just copying the information from the working driver in that file into the place of the orinoco_pci slot?
> I can't seem to find information on your card anywhere, do you have lspci > output we can use to identify the card? Here's the relevant information from the lspci:: 00:06.0 Network controller: Harris Semiconductor: Unknown device 3890 (rev 01) > I suspect the error is lack of fully implimenting wireless extensions > (what wireless-tools uses) in the ndiswrapper driver. I don't think that it would be just the ndiswrapper driver beacuse on another distro, I got the prism54 driver [http://www.prism54.org] to the same level. Could it be that there's something lacking in the current disto's wireless-tools? Another thing that caught my eye is that in an iwconfig output I get:: eth0 NOT READY! ESSID:off/any Mode:Managed Channel:6 Access Point: 00:00:00:00:00:00 Tx-Power=31 dBm Sensitivity=0/0 Retry min limit:0 RTS thr=0 B Fragment thr=0 B Encryption key:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 I could connect to the AP with windows under these settings, but I don't know what the NOT READY! means (other than the obvious). Is that because the interface isn't up, or some other inherent problem with how I set it up? Mode, ESSID, and channel were the only things iwconfig would let me set. When I tryed to set rate to "auto" [I assume the default, but I tried to set it just in case], I got this output:: Error for wireless request "Set Bit Rate" (8B20) : SET failed on device eth0 ; Input/output error. Thanks for your fast response to my last one, -Alex -- ___________________________________________________________ Sign-up for Ads Free at Mail.com http://promo.mail.com/adsfreejump.htm
