On 15.02.12 peter ([email protected]) wrote: Moin,
> es ergibt sich folgendes: > > cat /proc/partitions es kommen sda und sda1 hinzu. > sda ist 488386584 Bytes > gross, sda1 488384001 Bytes. > Die Platte hat lt. Angabe des Herstellers 500 GB. > > ls /sys/block es kommt sda hinzu > > dmesg die zusätzlichen Zeilen sind: > > sda: Write Protect is off > sda: Mode Sense: 38 00 00 00 > sda: assuming drive cache: write through SCSI device sda: 976 773 168 > 512.byte hdwr sectors (500 108 MB) > sda: Write Protect i8s off > sda: Mode Sense: 38 00 00 00 > sda: assuming drive cache: write through > sda: sda1 > sd 2:0:0:0: Attached scsi disk sda > usb storage: device scan complete > Na das sieht doch alles gut aus. Kannst Du das Ding (also sda1) als root mounten? Falls es bei der Error Message mit dem dirty bleibt, wirst Du wohl das machen müssen was da steht: die Platte einem echten W$ unterschieben und einen FS-Check machen. H. -- Computers are not intelligent. They only think they are. http://www.hilmar-preusse.de.vu/
signature.asc
Description: Digital signature
_______________________________________________ Lug-dd maillist - [email protected] https://ssl.schlittermann.de/mailman/listinfo/lug-dd
