[EMAIL PROTECTED] wrote: > Did u install from sources or rpm ? I usually love the source > approach since u get to to have greater control of the entire setup. > Though rpms r meant to make life easier, I think we luggers are > better of with the source approach. > > Wire
Well, you could install the source RPM of a package and recompile its corresponding .spec file, and rebuild it into an RPM, if that's what you mean. Very useful if a package was built to the distributor's pristine requirements. > > Kiggundu Mukasa said: >> set it up once and did not have that problem. >> I suggest you remove the security packages you have and then >> reinstall them and freeswan together. There may be settings in the >> other security packages that are not "freeswan-aware". >> >> kiggs >> >> On Sat, 2003-12-20 at 18:16, Kabagambe Kenneth wrote: >> >>> hi. i was wondering if any someone setting up ipsec has encountered >>> this: >>> >>> unregister_netdevice: waiting for ipsec0 to become free >>> >>> At this point, the system stops responding to any commands. >>> ifconfig /sudo/su dont repond either. >>> >>> This is on SuSE 8.2 running freeswan 1.99 with ipsec enabled >> >> -- >> **************** >> ***************************** Kiggundu Mukasa >> # Computer Network Consultancy### KYM-NET LTD. >> # Intranets & Internet Solutions# Plot 80 Kanjokya Street >> P.O. Box 24284 Kampala, Uganda >> Tel: +256 77 972255 >> +256 71 221141 >> Fax: +256 31 262122 >> ********************************************************************** >> *** Regards, Mark Tinka Technical Manager, Africa Online Swaziland --------------------------------------------- This service is hosted on the Infocom network http://www.infocom.co.ug
