I still get the same Error when i go to check for the Squid folder. ur/sbin/
No such file or Directory. Am stuck at this point am not sure where its been compiled at . On Mon, Jul 2, 2012 at 4:23 PM, Edmonds Namasenda <[email protected]> wrote: > Erasmus, > > I believe there is no need to recompile if the previous one finished > successfully. > Just start the service as advised. > > # Edmonds > > > On Mon, Jul 2, 2012 at 4:18 PM, aredo erasmus <[email protected]> wrote: >> >> Ok Let me re-compile and look out for that . >> Fedora 9 is the distro >> >> On Mon, Jul 2, 2012 at 4:16 PM, Benjamin Tayehanpour >> <[email protected]> wrote: >> > Or just have a look in /etc/init.d and see if anything similar to squid >> > is >> > in there. >> > >> > >> > On 2 July 2012 16:14, Edmonds Namasenda <[email protected]> wrote: >> >> >> >> What is the distro you are using? >> >> The service name could be "squid3" instead of just "squid". >> >> >> >> Remember to enable it to start at boot time. >> >> >> >> # Edmonds >> >> >> >> >> >> On Mon, Jul 2, 2012 at 4:09 PM, aredo erasmus <[email protected]> >> >> wrote: >> >> > I have downloaded and compiled it but when i try to start up the >> >> > squid >> >> > service this below is what i get . >> >> > >> >> > root@localhost squid-3.1.20-20120702-r10456]# service squid start >> >> > squid: unrecognized service >> >> > >> >> > >> >> > please advise on where i could be going wrong . >> >> > >> >> > On Mon, Jul 2, 2012 at 2:49 PM, Benjamin Tayehanpour >> >> > <[email protected]> wrote: >> >> >> Don't underestimate the placebo effect, eh? :) >> >> >> >> >> >> >> >> >> On 2 July 2012 14:46, Edmonds Namasenda <[email protected]> wrote: >> >> >>> >> >> >>> No. It will not work! >> >> >>> It's like expecting your car to run on turbo when not actually >> >> >>> installed, but rather have a lever / switch to mimic it's >> >> >>> initiation. >> >> >>> >> >> >>> Back-up your config, and re-compile. >> >> >>> >> >> >>> # Edmonds >> >> >>> >> >> >>> On Mon, Jul 2, 2012 at 1:10 PM, aredo erasmus <[email protected]> >> >> >>> wrote: >> >> >>> > Hi Guys , >> >> >>> > >> >> >>> > If initially when installing Squid you dont compile the ICAP >> >> >>> > interface >> >> >>> > >> >> >>> > ./configure--enable-icap-client >> >> >>> > >> >> >>> > i.e, You dont run the above command at compiling will it be >> >> >>> > possible >> >> >>> > to have the service run at >> >> >>> > >> >> >>> > icap_enable on >> >> >>> > >> >> >>> > Please let me know if it needs re-compiling or there is a work >> >> >>> > around. >> >> >>> > >> >> >>> > Regards >> >> >>> > Erasmus >> >> >>> > _______________________________________________ >> >> >>> > The Uganda Linux User Group: http://linux.or.ug >> >> >>> > >> >> >>> > Send messages to this mailing list by addressing e-mails to: >> >> >>> > [email protected] >> >> >>> > Mailing list archives: >> >> >>> > http://www.mail-archive.com/[email protected]/ >> >> >>> > Mailing list settings: http://kym.net/mailman/listinfo/lug >> >> >>> > To unsubscribe: http://kym.net/mailman/options/lug >> >> >>> > >> >> >>> > The Uganda LUG mailing list is generously hosted by INFOCOM: >> >> >>> > http://www.infocom.co.ug/ >> >> >>> > >> >> >>> > The above comments and data are owned by whoever posted them >> >> >>> > (including >> >> >>> > attachments if any). The mailing list host is not responsible for >> >> >>> > them in >> >> >>> > any way. >> >> >>> _______________________________________________ >> >> >>> The Uganda Linux User Group: http://linux.or.ug >> >> >>> >> >> >>> Send messages to this mailing list by addressing e-mails to: >> >> >>> [email protected] >> >> >>> Mailing list archives: http://www.mail-archive.com/[email protected]/ >> >> >>> Mailing list settings: http://kym.net/mailman/listinfo/lug >> >> >>> To unsubscribe: http://kym.net/mailman/options/lug >> >> >>> >> >> >>> The Uganda LUG mailing list is generously hosted by INFOCOM: >> >> >>> http://www.infocom.co.ug/ >> >> >>> >> >> >>> The above comments and data are owned by whoever posted them >> >> >>> (including >> >> >>> attachments if any). The mailing list host is not responsible for >> >> >>> them >> >> >>> in >> >> >>> any way. >> >> >> >> >> >> >> >> >> >> >> >> _______________________________________________ >> >> >> The Uganda Linux User Group: http://linux.or.ug >> >> >> >> >> >> Send messages to this mailing list by addressing e-mails to: >> >> >> [email protected] >> >> >> Mailing list archives: http://www.mail-archive.com/[email protected]/ >> >> >> Mailing list settings: http://kym.net/mailman/listinfo/lug >> >> >> To unsubscribe: http://kym.net/mailman/options/lug > > > _______________________________________________ > The Uganda Linux User Group: http://linux.or.ug > > Send messages to this mailing list by addressing e-mails to: [email protected] > Mailing list archives: http://www.mail-archive.com/[email protected]/ > Mailing list settings: http://kym.net/mailman/listinfo/lug > To unsubscribe: http://kym.net/mailman/options/lug > > The Uganda LUG mailing list is generously hosted by INFOCOM: > http://www.infocom.co.ug/ > > The above comments and data are owned by whoever posted them (including > attachments if any). The mailing list host is not responsible for them in > any way. -- relapse _______________________________________________ The Uganda Linux User Group: http://linux.or.ug Send messages to this mailing list by addressing e-mails to: [email protected] Mailing list archives: http://www.mail-archive.com/[email protected]/ Mailing list settings: http://kym.net/mailman/listinfo/lug To unsubscribe: http://kym.net/mailman/options/lug The Uganda LUG mailing list is generously hosted by INFOCOM: http://www.infocom.co.ug/ The above comments and data are owned by whoever posted them (including attachments if any). The mailing list host is not responsible for them in any way.
