-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On Fri, 10 Aug 2007 11:46:51 -0300 Horacio Castellini <[EMAIL PROTECTED]> wrote:
> Holas... > > Tengo un problema... en una máquina con dos tarjetas PCI, que son > reconocidas por el kernel... > > [EMAIL PROTECTED]:~$ dmesg|grep eth > eth0: RealTek RTL8139 at 0xda00, 00:e0:7d:9f:6f:4e, IRQ 9 > eth0: Identified 8139 chip type 'RTL-8139C' > eth1: RealTek RTL8139 at 0xdc00, 00:e0:7d:d8:08:2f, IRQ 11 > eth1: Identified 8139 chip type 'RTL-8100B/8139D' > eth0: link up, 100Mbps, full-duplex, lpa 0x45E1 > eth0: no IPv6 routers present > > la eth1 no es posible levantarla y no sé porqué... el error que da e el > siguiente.. > > [EMAIL PROTECTED]:~$ sudo ifup eth1 > SIOCSIFADDR: No such device > eth1: ERROR while getting interface flags: No such device > SIOCSIFNETMASK: No such device > SIOCSIFBRDADDR: No such device > eth1: ERROR while getting interface flags: No such device > eth1: ERROR while getting interface flags: No such device > Failed to bring up eth1. > > sin embargo figura como dispositivo PCI... > 00:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. > RTL-8139/8139C/8139C+ (rev 10) > 00:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd. > RTL-8139/8139C/8139C+ (rev 10) > > Que es lo que pasa...??? que módulo diferente al 8139cp y 8139too debo > usar...? > > Saludos... > IMHO, es un problema con el modulo, el 8139too anda bien, yo tenia dos placas de esas y con el 8139too funcionaba bien, sino es cuestion de probar :) - -- H^n(L,G) -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.6 (GNU/Linux) iD8DBQFGvdvEycqrDiz6CEARArWoAJ4gAz906mlcyVDg4wHAK15o2oWMzACfcM6t OE6yePBjL0rwUdJf3RQ7pzM= =Y6XZ -----END PGP SIGNATURE----- _______________________________________________ Lugro mailing list [email protected] http://www.lugro.org.ar/mailman/listinfo/lugro
