Hi,
I have a following command line:
mkfs.lustre --fsname datafs --ost [EMAIL PROTECTED] /dev/sdb
Does --mgsnode above is correctly specified if MGS resides on the
same node that OST?
Host-name of the node is storage01 and modprobe.conf contains
following line: options lnet networks=tcp0(eth0)
cheers
Wojciech Turek
On 11 Jul 2007, at 20:54, Brian J. Murrell wrote:
On Wed, 2007-07-11 at 20:45 +0100, Wojciech Turek wrote:
Ok but that was pasted from Lustre 1.6 manual.
Oh, this is not good then. I will look into that.
On the node I created MGS and MDT on /dev/sda6,
OK.
also on the same node
I have four other block devices sdb,sdc,sdd,sde, how I should
construct the command line to create four OST for this block devices.
Same command line for all four, just substitute the correct devices.
Then create a mountpoint for them all "mkdir /mnt/ost{0,1,2,3}" and
then
mount the devices under each OST mount point.
b.
_______________________________________________
Lustre-discuss mailing list
[email protected]
https://mail.clusterfs.com/mailman/listinfo/lustre-discuss
_______________________________________________
Lustre-discuss mailing list
[email protected]
https://mail.clusterfs.com/mailman/listinfo/lustre-discuss
