Hi, i'm not an expert in lustre but, reading the manual i understood that this is automatically done using the parameter in /etc/modprobe.conf
options lnet network=tcp0(eth0,eth0) this options tells Lustre to use both your network cards. Hope it helps you. On Jul 12, 5:10 pm, Wojciech Turek <[EMAIL PROTECTED]> wrote: > Hi, > > The OSS node I use has two network interfaces eth0 and eth2. > eth0 - 1Gb Ethernet > eth2 - 10Gb Ethernet > > I configured lnet to use eth2 but I am wondering if I could configure > lnet to use eth0 as well (as a failover for eth2) in case of network > failure on eth2 ? > Thank You for any suggestions > > Wojciech Turek > > _______________________________________________ > Lustre-discuss mailing list > [EMAIL PROTECTED]://mail.clusterfs.com/mailman/listinfo/lustre-discuss _______________________________________________ Lustre-discuss mailing list [email protected] https://mail.clusterfs.com/mailman/listinfo/lustre-discuss
