Hi Andreas, Thanks for the information you gave. But it did not help.
I followed the below steps for installation: 1) I did not install any kernel. The kernel is from rhel 5.1 2) I installed lustre-client-modules and lustre-client rpms. But the error messages are the same when i tried to mount the filesystem: mount.lustre: mount [EMAIL PROTECTED]:/klfs at /klfs failed: No such device Are the lustre modules loaded? Check /etc/modprobe.conf and /proc/filesystems Note 'alias lustre llite' should be removed from modprobe.conf And also when modprobing the lnet module the error message is same again: FATAL: Module lnet not found. Thanks anyway. I might have missed something. But i don't know what the thing is. I decided to install patched kernel and lustre packages. After installation client could mounted the file system. Thanks and Regards, Ender GULER On Thu, Aug 28, 2008 at 5:51 PM, Andreas Dilger <[EMAIL PROTECTED]> wrote: > On Aug 27, 2008 20:57 +0300, Ender G�ler wrote: > > I'm new to lustre community and lustre software as well. I have question > > regarding to patchless lustre client installation. The OS is Redhat EL > 5.1. > > I'm using voltaire gridstack v5.1.3 for infiniband software stack. I > > installed the lustre-1.6.5.1 servers without any problem. The client and > > server OSes are same. The problem is installing patchless client. Are > there > > any howto or guide for that. I googled but got nothing about it. Just the > > link http://wiki.lustre.org/index.php?title=Patchless_Client . When i > tried > > the things which i read on that page, no modules were build. Are there > > anything that must be done for the patchless client installation. > > > > I ran the following command for configuration: > > > > ./configure --prefix=/usr/local/lustre --enable-uoss --enable-bgl > > --enable-posix-osd --enable-panic_dumplog --enable-quota > > --enable-health-write --enable-lru-resize --enable-adaptive-timeouts > > --enable-efence --enable-libwrap --enable-snmp > --with-o2ib=/usr/src/openib > > --with-linux=/usr/src/kernels/2.6.18-53.1.14.el5 > > > > Then ran make && make install. None of the above steps returned error > > messages. So I assumed that the compilation and installation is > successful. > > But when i try to mount the server the following error message returned: > > There are actually patchless client RPMs available for download at the > same place as the server RPMs. They are called "lustre-client" or similar. > > Note that it is also possible to run the same "server" kernel and Lustre > RPMs on the client nodes, since the lustre RPM also contains the client. > > Cheers, Andreas > -- > Andreas Dilger > Sr. Staff Engineer, Lustre Group > Sun Microsystems of Canada, Inc. > >
_______________________________________________ Lustre-discuss mailing list [email protected] http://lists.lustre.org/mailman/listinfo/lustre-discuss
