Thanks Richard! Using the 1.8.6 CentOS 5 instructions I was able to successfully use git, configure, make rpms for what I needed. The "Provision Machine" instructions were followed exactly, and since I only needed client rpms, I skipped to the "Configure and Build Lustre" section, which produced the rpm's I needed.
Installing the RPM's was smooth, and after install Lustre mounted. One oddity, there is no /etc/modprobe.conf file to enter lnet options in, however everything seems to be mounting without error. Aaron On Fri, Aug 5, 2011 at 11:16 PM, Richard Henwood <[email protected]>wrote: > > On Fri, Aug 5, 2011 at 9:16 PM, Aaron Everett <[email protected]>wrote: > >> Is there a whamcloud version of a lustre-1.8.5.tar.gz or 1.8.6 that I can >> use to build rpms for RedHat/CentOS 6? (Specifically CentOS >> 6, 2.6.32-71.29.1.el6.x86_64) >> >> > Hi Aaron, > > There is a description on building from Whamcloud git on: > > http://wiki.whamcloud.com/display/PUB/Walk-thru-+Build+Lustre+2.1+on+RHEL+6.1+from+Whamcloud+git > > I recently worked through that page, updating for RHEL 6.1, so I'm not sure > on the page's applicability to CentOS 6. If you make progress (or otherwise) > I would appreciate feedback. > > Also, there is a page on building RPMs with 1.8.6, but that is for CentOS > 5: > > http://wiki.whamcloud.com/display/PUB/Walk-thru-+Build+Lustre+1.8+on+CentOS+5.5+or+5.6+from+Whamcloud+git > again, feedback is welcome. > > richard, > > <snip> >> > > -- > [email protected] > Whamcloud Inc. > tel: +1 512 410 9612 >
_______________________________________________ Lustre-discuss mailing list [email protected] http://lists.lustre.org/mailman/listinfo/lustre-discuss
