Hi Andrew. My scanner needs a firmware file to be downloaded and installed. Is this the same for Epson?. Although it has the driver (snapscan in my case), it still needs this firmware file - Mine is a Benq scanner (quite old). I often forget to install this file when I connect the scanner to a new PC and it will not be detected by sane without it, but will show in lsusb. Its possible too that I have had to install 32 bit libraries as well.
Usually you will find more info on the sane website under supported device section. Cheers Daniel. On 24/05/15 23:54, Andrew Greig wrote: > Hi All > > I have a SCSI scanner which normally "just works" under Linux. I have > just loaded a fresh OpenSuse 13.2 (64bit) OS. The scanner is found in > lspci and also in the hardware detection in Suse. For some reason XSANE > cannot see it. When using the scanner setup tool in the YAST , it > identifies the scanner but reports that the driver is not configured. > The driver should be the sane-epson2. What am I missing, please? > > > Andrew Greig > _______________________________________________ > luv-main mailing list > [email protected] > http://lists.luv.asn.au/listinfo/luv-main _______________________________________________ luv-main mailing list [email protected] http://lists.luv.asn.au/listinfo/luv-main
