I was just typing up a massive reply full of questions, but I think I see your problem.
The DIP is 91.121.30.157/24 The VIP is 87.98.225.39/32 The RIP is 91.121.20.31/24 The director has a default gw of 91.121.30.254 The director *does not have a direct route to 91.121.20.0/24*. Therefore the director sends the incoming SYN back to its' default gw; it is then passed back to the director, back to the gw, back to the director (and so on) until the TTL decrements to 0 and everyone gets "time exceeded in-transit" errors. In LVS-DR, the director *must have a direct route to the realservers* - or, at the very least, one which does not re-traverse the inbound gateway. Please read http://www.linuxvirtualserver.org/VS-DRouting.html making special note of the image which says that the director and realservers "Must be in a physical segment". Also from http://www.austintek.com/LVS/LVS-HOWTO/HOWTO/LVS-HOWTO.LVS-DR.html "LVS-DR setup and testing is the same as LVS-Tun except that all machines within the LVS-DR (ie the director and realservers) must be on the same segment (be able to arp each other). This means that there must be no forwarding devices between them i.e. they are using the same piece of transport layer hardware ("wire"), eg RJ-45, coax, fibre (there can be hub(s) or switch(es) in this mix). Communication within the LVS is by link-layer, using MAC addresses rather than IP's." Sort that out first. Then you'll work. Graeme _______________________________________________ LinuxVirtualServer.org mailing list - [email protected] Send requests to [EMAIL PROTECTED] or go to http://www.in-addr.de/mailman/listinfo/lvs-users
