Quoting Serge E. Hallyn ([email protected]): > Quoting Nirmal Guhan ([email protected]): > > Hi, > > > > I have a requirement to create two virtual interfaces (eth0, eth1) in > > a linux container and separate traffic between the two based on ip > > route. Basically eth0 (or eth1) should be used for external world and > > eth1 for communication terminating at host. How do I go about doing > > this? > > > > I created two interfaces in the config and can see both of them in the > > container. > > > > lxc.network.type = veth > > lxc.network.link = br0 > > lxc.network.ipv4 = 128.107.159.183/22 > > lxc.network.name = eth0 > > lxc.network.flags = up > > lxc.network.mtu = 1500 > > lxc.network.type = veth > > lxc.network.link = br0 > > If you want eth1 to be connected internally only, then shouldn't > you create a bridge br1, and use that here? Don't connect br1 > to the physical nic, and you'll have your host-only bridge.
(BTW, I assume that the reason you failed to ping then was that your eth1 in the container had an address on a different subnet, and - I assume - there was no route known on the host to that subnet. I could be wrong, but since your test seemed to be unrelated to your end goal I thought I'd comment first on how to do what you want) -serge ------------------------------------------------------------------------------ Download new Adobe(R) Flash(R) Builder(TM) 4 The new Adobe(R) Flex(R) 4 and Flash(R) Builder(TM) 4 (formerly Flex(R) Builder(TM)) enable the development of rich applications that run across multiple browsers and platforms. Download your free trials today! http://p.sf.net/sfu/adobe-dev2dev _______________________________________________ Lxc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/lxc-users
