The message below from Henry Tillotson
<[EMAIL PROTECTED]> was forwarded by
the list maintainer.
>Hello...
>
>apologies if this is an obvious question and/or the wrong forum for it.
>
>I've just downloaded lynx 2.8.2 from the site:
>
> http://www.fdisk.com/doslynx/lynxport.htm
>
>(file lynx_386.2.8.2rel.1.zip)... I'm running it on a 386 under Caldera
>DR-DOS 7.03. It works fine in local mode with the supplied dummy packet
>driver, but I can't get it to work with a real one... I keep getting the
>Alert message about not being able to contact the remote site.
>
>I'm using the DOSPPPD packet driver, which works fine with it's own
>(Clarkson) Telnet, and also with the Arachne graphical browser. I've
>tried editing the WATTCP.CFG file to match my ISP settings, but so far
>to no avail. Does this lynx port only work with the supplied TCPPORT.EXE
>file? if so, how do you use it? I can find no information on how to set
>up lynx to use any of these DOS packet drivers.
>
>any help, or pointers as to where I could find it, would be much
>appreciated
>
>thanks
>
>Henry Tillotson
>
>=====================================================================
>Henry Tillotson e-mail: [EMAIL PROTECTED]
>User Support phone: 020 7679 7827
>Information Systems fax: 020 7388 5406
>University College London, Gower Street, London WC1 E 6BT
>=====================================================================
; To UNSUBSCRIBE: Send "unsubscribe lynx-dev" to [EMAIL PROTECTED]
