On Fri, Aug 28, 2020 at 12:19:49PM +0200, Kornel Benko wrote: > Am Fri, 28 Aug 2020 12:02:30 +0200 > schrieb Pavel Sanda <[email protected]>: > > > On Fri, Aug 28, 2020 at 12:52:58AM +0200, Kornel Benko wrote: > > > Same result, \int is displayed, \oint is not seen, \ointclockwise is ok > > > ... and the > > > output from strace continues with > > > read(22, " ∫ esint\niin"..., 8191) = 8191 > > > write(2, "Failed to compute left/right min"..., 60Failed to compute > > > left/right minimum > > > bearings for "esint10" write(2, "Failed to compute left/right min"..., > > > 60Failed to > > > compute left/right minimum bearings for "esint10" write(2, "Failed to > > > compute > > > left/right min"..., 60Failed to compute left/right minimum bearings for > > > "esint10" > > > write(2, "Failed to compute left/right min"..., 60Failed to compute > > > left/right > > > minimum bearings for "esint10" > > > > Kornel, can you try whether the following version of esint will fix the > > issue with > > oiint ? (when you use it to replace esint10.ttf) > > > > Pavel > > Does not show in math-editor, but outside is ok. > \int \oint \oiint > Attached: 1st outside editor, 2nd insid
I am quite confused by your reports. Can you try whether replacing esint10.ttf with the attached version gets rid of "Failed to compute left/right minimum bearings for "esint10"" message? Also does it make any difference for display of characters? Pavel
esint10.ttf
Description: Binary data
-- lyx-devel mailing list [email protected] http://lists.lyx.org/mailman/listinfo/lyx-devel
