Lee,
I'll measure the legs when I get home tonight. I think the rubber feet will be
the hardest part to source. But something as simple as some Plasti Dip from
Home depot would solve the problem. One could make a tone of these by taking
the proper sized dowel, cutting it to length and dipping the ends in Plasti Dip.
Kurt
On Monday, July 31, 2017 10:57 PM, Lee Olivares <[email protected]> wrote:
On the legs, I just need measurements to produce a 3D model.
The rubber feet are probably just trivet feet.
- Lee Olivares
- (909) 437-0250
- The Future or Bust.
On Jul 31, 2017, at 22:46, ray gordon <[email protected]> wrote:
I don't remember who, but someone was just talking about legs. Could you donate
them to someone who has access to a 3d scanner, so we can 3d print them from
now on, instead of people eternally looking for them, and being unable to find
them?
From: M100 <[email protected]> on behalf of Kurt McCullum
<[email protected]>
Sent: Monday, July 31, 2017 10:01 PM
To: Model 100 Discussion
Subject: [M100] Super ROM/legs Just received my latest eBay purchase.
M100/TPDD2/Daisy wheel printer/legs and cables.I needed the 100 to test an
issue with mComm properly handling DTR/DSR. Apparently there is a slight
difference between the 100 and 102. The rest of the hardware was a bonus.But
back to the reason for the email. I already have a set of legs and I prefer the
SARDOS ROM so I'm not likely to use the Super ROM. If you are interested in
either one, contact me off list. I will let them go cheap.Kurt
