I get .339" x 2.175" (8.62mm x 55.24), rubber foot: .85" (21.6mm)
What do you get? You're right about the feet; I made a set from wooden dowel years ago and couldn't find any trivet feet that size; had to use tape and silicone. But a couple of pretty pencils and a little tape are still easiest. ----- Original Message ----- From: Kurt McCullum To: [email protected] Sent: Tuesday, August 01, 2017 10:20 AM Subject: Re: [M100] Super ROM/legs Lee, I'll measure the legs when I get home tonight. I think the rubber feet will be the hardest part to source. But something as simple as some Plasti Dip from Home depot would solve the problem. One could make a tone of these by taking the proper sized dowel, cutting it to length and dipping the ends in Plasti Dip. Kurt On Monday, July 31, 2017 10:57 PM, Lee Olivares <[email protected]> wrote: On the legs, I just need measurements to produce a 3D model. The rubber feet are probably just trivet feet. - Lee Olivares - (909) 437-0250 - The Future or Bust. On Jul 31, 2017, at 22:46, ray gordon <[email protected]> wrote: I don't remember who, but someone was just talking about legs. Could you donate them to someone who has access to a 3d scanner, so we can 3d print them from now on, instead of people eternally looking for them, and being unable to find them? ------------------------------------------------------------------------------ From: M100 <[email protected]> on behalf of Kurt McCullum <[email protected]> Sent: Monday, July 31, 2017 10:01 PM To: Model 100 Discussion Subject: [M100] Super ROM/legs Just received my latest eBay purchase. M100/TPDD2/Daisy wheel printer/legs and cables. I needed the 100 to test an issue with mComm properly handling DTR/DSR. Apparently there is a slight difference between the 100 and 102. The rest of the hardware was a bonus. But back to the reason for the email. I already have a set of legs and I prefer the SARDOS ROM so I'm not likely to use the Super ROM. If you are interested in either one, contact me off list. I will let them go cheap. Kurt
