Josh, Thanks for the reply. I've removed the NiCD battery as it looked kinda sad, I'll measure the voltages and get the oscilloscope out to make sure the crystals are okay still...thank you for the information, any information is extremely helpful!
Thanks, Britt On Fri, Nov 16, 2018, 4:50 PM Josh Malone <[email protected] wrote: > I'll see if I can identify the case screws on my 200. > > Also, make sure you check the memory power supply voltage (pin 28 on > the RAM chips, I think) - it should be a solid 5v. If your memory > battery is still installed and is discharged it can drag this rail > down. > > -Josh > > On Tue, Nov 13, 2018 at 4:14 PM Britt Dodd <[email protected]> wrote: > > > > Thanks Kurt --- the machine is absolutely non-responsive > (basic,enter,beep,enter does nothing), so I suspect removing the battery > might be a better first step, rather than immediately breaking the probe > out.... > > > > Does anybody have measurements on what the case screws dimensions are > (length, thread size, pitch)? All 3 of the 200s were missing case screws, > which I'd eventually like to remediate. >
