>From what I can tell the spacing et al of the Rex is the same as the SR. The >PCB of the Rex is thinner material than the SR, but the top surface of both is >level/even when the two are set next to each other. I have made some adjusting >attempts with near same result. Even installed the Rex in one of my other MT >and had the same issue there.
I was trying to load TS-DOS injected via mComm 2.5, but that is giving me an OD, Out of Data, error in line 5. It's my hope that the rf149.co might have enough "diagnosis" that it can tell if the Rex is in/programmed/whatever to further figure out what is wrong. Sill looking for a way to load TS-DOS, anyone have a suggestion? God Bless, Greg ----- Original Message ----- From: "John R. Hogerhuis" <[email protected]> To: [email protected] Sent: Tuesday, January 22, 2019 7:10:41 PM Subject: Re: [M100] Unable to Load TEENY to MT In my experience it's an issue of good contact pressure between all pins and the socket, and the proper spacer between rex and the socket bottom. -- John.
