Bob, There are 100 and 200 versions.
Eric, John (the author of HTERM) will have to chime in on the details but as I recall, there are no settings. I believe the baud rate is fixed at 19200. The main advantage to HTERM is that is uses CTS/RTS instead of XON/XOFF like TELCOM does. It also does some conversion of the data stream to match the character set of the m100. Make sure your cable has the CTS/RTS wires in their proper location. Kurt On Mon, Jul 15, 2019, at 8:59 AM, [email protected] wrote: > I could easily be wrong, but I think HTERM is only for the T200. > Bob > > -----Original Message----- > From: M100 <[email protected]> On Behalf Of Eric LK > Sent: Monday, July 15, 2019 10:08 AM > To: [email protected] > Subject: [M100] Using HTERM on a M100 > > Hi, > > I'm probably missing something very obvious, but I've tried everything I > could think of and I'm out of ideas :o) > > I've been trying to use HTERM on my M100, but all I get is a white screen, > until I press F8 which exits the application and returns to the menu. > > I found the application on the > http://bitchin100.com/wiki/index.php?title=HTERM page and didn't had any > issue loading or launching the HTERM.CO file (I don't think this is an HIMEM > issue). I just cannot figure out where are the instructions to configure and > use the application... I even tried sending DATA from the connected PC at > various speeds, and nothing happen. > > I may just be very tired, but I would appreciate if someone could push me in > the right direction. > > Eric > >
